User manual

programme: this is indicated by a blinking zero.
The zero will reappear when you switch the
washing machine on, unless the previous
programme has been erased by means of the
SKIP RESET button.
Important!
The first time you use the washing machine,
when you switch it on, it may display a blinking zero
and give an audible warning signal. This is due to the
fact that the washing machine has performed a
washing cycle during the manufacturer’s inspection
tests, and this cycle has not been erased after its
completion.
• Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button,
the countdown begins, and the delay time value
decreases by one unit every hour till the first 2
hours, and then it decreases by one unit every 30
minutes.
You can delay the start of every programme
selecting the DELAY START button. The delay time
is indicated first by 30-60-90 minutes, and then by
hours up to 23 hours.
• An incorrect option selection has been made:
this is indicated by the message Err when a
function incompatible with the current programme
is selected.
The incorrect selection is also indicated by an
audible warning signal.
• An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 23).
9 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
If you have selected a delay time by means of the
relevant button, the countdown will begin and will
be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
10 SKIP RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear and the audible warning signals relevant to
the end of the previous cycle will be given.
You can also press the SKIP RESET button to
exclude one or several phases of the programme
12
132987260.qxd 23/03/2005 11:05 Pagina 12 (Nero/Process Black pellicola)