User manual

ENGLISH
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the
START/PAUSE button;
• press the SKIP RESET button repeatedly, until only
the DRAIN light remains lit;
• press the START/PAUSE button again.
When the water has been drained, the display shows
a blinking zero. You may now select a new
programme and press the START/PAUSE button to
start it.
12. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF
button again, the washing machine will resume the
programme from the point where it had been
interrupted.
13. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, and
displays a blinking zero.
If you had selected the RINSE HOLD or NIGHT
CYLCE option , the light of the START/PAUSE
button goes out, the zero on the display begins to
flash, the door is locked and RINSE HOLD or NIGHT
CYCLE light remains lit.
To complete the cycle, first press the SKIP RESET
button (3 dashes appear on the display), and then
choose one of the following options:
drain only:
- press the FABRICS button to choose any type of
fabric, press the SKIP RESET button (10) 3
times, so as to cause the light DRAIN to light
up, and then press the START/PAUSE button.
drain and spin:
- press the FABRICS button to select the type of
fabric previously washed, eventually reduce the
spin speed, and then press the SKIP RESET
button twice, so as to cause the light SPIN to
light up, and at the end press the START/PAUSE
button.
When the programme has been completed, a
blinking zero appears on the display and the audible
signal is given.
Press the SKIP RESET button repeatedly to erase
the programme that has just been carried out. If
you omit to do this, the next time you switch the
washing machine on, the blinking zero will
appear on the display and you will hear the
audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the FABRICS button and select a
new programme.
Press the ON/OFF button to switch the machine off.
The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking) or
bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.
19
132987260.qxd 23/03/2005 11:05 Pagina 19 (Nero/Process Black pellicola)