User manual

b. Touch the button until the
indicator above this button goes
off.
Touch the button again to
start the programme
immediately.
10.9 Interrupting a programme
and changing the options
You can change only some options
before they operate.
1. Touch
.
The indicator of this button flashes.
2. Change the options. If you change
any option the Finish In option (if set)
will be disabled.
3. Touch again.
The programme continues.
10.10 Cancelling a programme
1. Press the button for some
seconds to cancel the programme
and to deactivate the appliance.
2. Press the same button again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.11 Opening the door
While a programme (or the ) operates,
the appliance door is locked. The
indicator
is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
To open the door during the first
minutes of the cycle (or when the
operates) :
1. Touch the button to pause the
appliance.
2. Wait until the indicator goes off.
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the
) continues.
10.12 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display comes on.
• The indicator of the button goes
off.
• The door lock indicator goes off.
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Press the button
for some seconds
to deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent
drawer ajar, to prevent the mildew
and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The indicator flashes to remind
you to drain the water.
• The door lock indicator is on. The
indicator of button
flashes. The
door stays locked.
• You must drain the water to open the
door.
Draining the water:
1. To drain the water.
• Touch the button
. The
appliance drains the water and
spins with the maximum spin
speed for selected washing
programme.
• Alternatively, touch the button
to change the spin speed and
www.electrolux.com38