User manual

18
Water is leaking out underneath
the washing machine.
Screw connection on the inlet hose
is leaking.
Tighten inlet hose.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not closed
properly.
Close cover properly.
Washing was caught in the door.
Load washing carefully for the next
wash.
Emergency drain hose is leaking.
Close off emergency drain hose prop-
erly.
EF0 appears. END indicator
flashes 15x, at the same time
an acoustic signal sounds 15x.
The drain pump runs constant-
ly, even when the machine is
switched off.
The Aqua Control anti-flood system
has responded.
Turn off the tap, remove the mains
plug from the socket and contact the
Customer Care Department.
Washing water is foaming ex-
cessively. At the end of the
washing cycle, the spin stops.
OVER DOSING indicator is lit.
Probably too much detergent has
been used.
Dose detergent exactly as instructed
by manufacturer.
E20 appears.
END indicator flashes 2x, at the
same time an acoustic signal
sounds 2x.
(Problems with water outflow.)
Kink in the drain hose. Remove kink.
Maximum pumping height of 1m ex-
ceeded.
Please contact the Customer Care
Department.
Drain pump is blocked.
Switch off appliance. Pull out mains
plug.
Clean drain pump. Remove foreign
bodies from pump housing.
With connection to sink outlet: sink
outlet is blocked.
Clean out sink outlet.
Conditioner not rinsed in, w
compartment for additives is
filled with water.
Conditioner insert in the compart-
ment for additives is not correctly at-
tached or is blocked.
Clean detergent dispenser drawer, in-
sert conditioner insert firmly.
Door cannot be opened when
appliance is switched on.
Door locked. Wait until DOOR indicator is lit green.
Power cut. (All display indicators are
off.)
Door remains locked for 4 to 10 min-
utes.
Programme continues, when power
cut is over.
To rem ove was hing:
If water can be seen in the appliance,
before opening the door, first drain off
the water. (See section “Carrying out
an emergency drain”.)
Washing is heavily creased.
Possibly too much washing was
loaded.
Observe maximum loads.
Problem Possible cause Remedy