User manual

27
Making the appliance level
The four feet of the appliance are pre-adjusted.
Large degrees of unevenness can be compensated
for by individually adjusting the height adjustable
screw feet.
Use the special spanner supplied to do this.
Important! Do not use pieces of wood, cardboard or
such like to level out unevenness in the floor, but ad-
just the height adjustable screw feet instead.
Electrical connection
Details about the voltage, type of supply and the fus-
es required are to be found on the rating plate. The
rating plate is next to the doorway.
Connecting to the water supply
Important!
• This appliance must not be connected to the hot
water system.
• When connecting it, use only new hose kits.
• Only connect the appliance to the drinking water
supply. Rain water or water for industrial use may
only be used if it fulfils the requirements of
DIN1986 and DIN1988.
• Do not kink or crush the water inlet hose or drain
hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/
cm
2
=0.1MPa) and may be a maximum of 10bar
(=100N/cm
2
=1MPa).
– If more than 10bar: Connect a pressure reduction
valve.
– If less than 1bar: Disconnect the appliance end of
the inlet hose from the solenoid inlet valve and re-
move the flow meter. (In addition remove the filter
using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.