User manual

10.7 Starting a programme
without the Finish In option
Touch the button .
• The indicator of the button
stops to flash and stays on.
• The programme starts, the door
locks, the indicator is on.
• The drain pump can operate for a
short time at the beginning of the
washing cycle.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
10.8 Starting a programme with
the Finish In option
1. Touch the button again and again
to choose the number of hours in
which you want the washing cycle to
be finished.
The display shows the number of hours
you set (e.g. ) and the indicator above
the button
is on to show that his
option is active.
2. Touch the button :
• The door is locked.
• The appliance starts the
countdown.
• When the countdown is
completed, the programme starts
automatically.
You can cancel or change
the set of the Finish In option
before you touch the button
. After touching the
button you can only
cancel the Finish In option.
To cancel the the Finish In option:
a. Touch the button to set the
appliance to pause. The indicator
of button flashes.
b. Touch the button until the
indicator above this button goes
off.
Touch the button again to
start the programme
immediately.
10.9 Interrupting a programme
and changing the options
You can change only some options
before they operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change
any option the Finish In option (if set)
will be disabled.
3. Touch again.
The programme continues.
10.10 Cancelling a programme
1. Press the button for some
seconds to cancel the programme
and to deactivate the appliance.
2. Press the same button again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.11 Opening the door
While a programme (or the ) operates,
the appliance door is locked. The
indicator is on.
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
www.electrolux.com14