User manual

Problem Possible solution
The appliance makes
an unusual noise.
• Make sure the levelling of the appliance is correct. Refer
to 'Installation instruction'.
• Make sure that the packaging and/or the transit bolts
are removed. Refer to 'Installation instruction'.
• Add more laundry in the drum. The load may be too
small.
The cycle is shorter
than the time displayed.
• The appliance calculates a new time according to the
laundry load. See the ‘Consumption Values’ chapter.
The cycle is longer than
the time displayed.
• An unbalanced laundry load increases the duration time.
This is a normal behaviour of the appliance.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains be‐
fore you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
You cannot set an op‐
tion.
• Make sure that you press only the wanted touch but‐
ton(s).
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
13.3 Service
We recommend the use of original spare
parts.
When contacting the Authorised Service
Centre, make sure that these data are
available. You can find the information
on the rating plate: model, PNC and
Serial Number. (Mod., Prod. No., Ser.
No.)
14. TECHNICAL DATA
Dimension Width/ Height/ Depth/
Total depth
600 mm/ 850 mm/ 600 mm/ 660
mm
Electrical connection Voltage
Overall power
Fuse
Frequency
220 - 240 V
2200 W
13 A
50 Hz
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
IPX4
ENGLISH 23