User manual

ManualsBrandsElectrolux ManualsData Input DevicesEWF1408WDL2

Problem Possible solution

Add more laundry in the drum. The load may be too small.

The cycle is shorter

than the time displayed.

The appliance calculates a new time according to the laun‐

dry load. See the ‘Consumption Values’ chapter.

The cycle is longer than

the time displayed.

An unbalanced laundry load increases the duration time.

This is a normal behaviour of the appliance.

The washing results are

not satisfactory.

Increase the detergent quantity or use a different deter‐

gent.

Use special products to remove the stubborn stains before

you wash the laundry.

Make sure that you set the correct temperature.

Decrease the laundry load.

You cannot set an op‐

tion.

Make sure that you press only the wanted button(s).

The drum is empty and

the display shows there

is some weight in.

Press button Auto Off to deactivate the appliance and acti‐

vate it again to set a tare.

The drum is full but the

display shows 0.0 kg.

You loaded the laundry before activating the appliance.

Press button Auto Off to deactivate the appliance.

Empty the drum and obey to the necessary steps. (Refer to

'Loading the laundry')

The drum light does not

go on.

Make sure that you activate the appliance. Refer to 'Daily

Use'.

After the check, activate the appliance. The programme continues from the point of

interruption.

If the problem occurs again, contact the Authorised Service Centre.

If the display shows other alarm codes. Deactivate and activate the appliance. If the

problem continues, contact the Authorised Service Centre.

14. EMERGENCY DOOR OPENING

In case of power failure or appliance

failure the appliance door remains

locked. The washing programme

continues, when the power is restored. If

the door remains locked in case of

failure, it is possible to open it using the

emergency unlock feature.

Before opening the door:

CAUTION!

Make sure that the water

temperature and the

laundry are not hot. Wait

till they cool down, if

necessary.

CAUTION!

Make sure that the drum is

not rotating. Wait till the

drum stops rotating, if

necessary.