User manual

17
11. How to change an option or a
programme during its cycle
Before you make any change, you must PAUSE the
machine by pressing the Start/Pause button. It is
possible to change the temperature or any option
before the programme carries it out.Changing a
running programme is possible only by cancelling it
and selecting a new programme. The machine will
resume the cycle from the beginning and the
washing water in the tub will not emptied out.
If it is necessary to drain the water in order to change
the programme in progress, proceed as follows:
• PAUSE the machine by pressing the Start/Pause
button;
• press the Skip Reset button repeatedly, until only
the Drain light remains lit;
• press the Start/Pause button again.
When the water has been drained, the display shows
a blinking zero. You may now select a new
programme and press the Start/Pause button to
start it.
12. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
Start/Pause button, then press the Skip Reset
button repeatedly, until the display shows three
blinking dashes.
13. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following
conditions exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door locked light goes off and
the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the On/Off button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the On/Off
button again, the washing machine will resume the
programme from the point of where it had been
interrupted.
14. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, the
Start/Pause button light goes off, and the display
shows a blinking zero. If you have selected the Night
Cycle option, the door is locked (the door locked
light is on), the Start/Pause button light goes off, the
pilot light of Night Cycle remains lit to indicate that
the water must be drained.The display shows a
flashing zero. When the programme has been
completed, a blinking zero appears on the display
and the audible signal is given. The door locked light
goes off. Press the Skip Reset button repeatedly to
erase the programme that has just been carried out.
If you omit to do this, the next time you switch the
washing machine on, the flashing zero will appear on
the display and you will hear the audible signal
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the Fabric button and select a
new programme. Press the On/Off button to switch
the machine off. The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get
damaged in a subsequent wash (e.g. by shrinking) or
bleed colour into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing
machine.