User manual

21
Drain filter
The drain filter collects threads and small objects
inadvertently left in the laundry. Check regularly that
the filter is clean.
Open the filter door by pulling it towards the right.
Place a container under the filter to catch any
spillage.
Release the emergency emptying hose, place it in
the container, and remove its cap by unscrewing it.
When no more water comes out, unscrew the filter
and remove it.
Clean the filter under a running tap, then refit it,
screwing it fully in.
Put the cap back on the emergency emptying hose,
place the latter back in its seat. Close the filter door.
P0040
P1061
P1085
P1062
Water inlet filter
If you notice that the machine is taking longer to fill,
check that the filter in the water inlet hose is not
blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter with a stiff brush.
Screw the hose back onto the tap.
Emergency emptying out
If the machine is unable to drain, proceed as follows
to empty out the machine:
• Pull out the plug from the power socket.
• Close the water tap.
• If necessary, wait until the water has cooled
down.
• Place a bowl on the floor under the filter and
place the end of the emergency emptying hose
into the bowl. The water should drain by gravity
into the bowl. When the bowl is full, screw the cap
on again. Empty the bowl. Repeat the procedure
until water stops flowing out.
• Clean the filter if necessary.
• At the end screw the filter again.
P1090