User manual

essary, check the setting with a spirit level.
Any necessary adjustment can be made
with a spanner. Accurate levelling prevents
vibration, noise and displacement of the
machine during operation.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor.
INSTALLATION ON SUSPENDED
FLOORING
Suspended wooden floors are particularly
susceptible to vibration.
To help prevent vibration we recommend
you place a waterproof wood panel, at least
15 mm thick under the appliance, secured
to at least 2 floor beams with screws, the
wood panel must extend beyond the front
feet.
If possible install the appliance in one of the
corners of the room, where the floor is
more stable.
Warning! The appliance should NOT
be placed on deep pile carpeting.
Note!
Please ensure that when the appliance
is installed it is easily accessible for the
engineer in the event of a breakdown.
WATER INLET
The inlet hose is supplied with the appli-
ance and can be found inside the machine
drum.
Warning! This appliance must be
connected to a cold water supply.
1. Connect the water inlet hose to a tap
with a 3/4" thread. Always use the hose
supplied with the appliance.
Important! Do not use the hose from
your previous machine to connect to
the water supply.
2. Connect the appropriate end of the
hose to the appliance with the angled
connection as showed in the picture.
45°
35°
Do not place the inlet hose down-
wards.
Angle the hose to the left or right de-
pending on the position of your water
tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Important! Before connecting up the
machine to new pipework or to pipework
that has not been used for some time, run
off a reasonable amount of water to flush
out any debris that may have collected in
the pipes.
24 electrolux