User manual

11.Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
12.Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button .
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
selector dial to “O”. After about 3 minutes the door can
be opened (pay attention to the water level and
temperature!).
13.At the end of the programme
The machine stops automatically.
The START-PAUSE pilot light goes out and the
END pilot light comes on. The door can be
opened.
If the Rinse Hold option has been selected and
the door is locked to indicate that the water must be
emptied out before opening the door.
To do this turn the programme selector dial to “O”
and then to programme (drain) or (short
spin). The spin programme is performed at the
maximum speed. You can reduce the spin speed by
turning the spin speed selector dial.
Switch the machine off by turning the programme
selector dial to “O”.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
16
7. Select the DELAY START
Before you start the programme, if you wish the
starting to be delayed, press the DELAY START
button repeatedly, to select the desired delay. The
relevant light illuminates.
8. Start the programme
To start the selected programme, press the
START/PAUSE button , the corresponding light
stops flashing and remains lit.
The light illuminates.
If you have chosen a delayed start, the machine will
begin the countdown.
9. Altering the programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
START/PAUSE button .
10.Interrupting a programme
Depress the START/PAUSE button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart
the programme.
8 H
4 H
132990710 GB.qxd 02/03/2004 11:42 Pagina 16 (Nero/Process Black pellicola)