User manual

24 www.electrolux.com
To clean the water inlet filters:
1. Close the water tap.
2.
3.
4. Remove the inlet hose behind
the appliance.
5. Clean the filter in the valve with
a stiff brush or a towel.
6. Install again the inlet hose.
Make sure that the couplings are
tight to prevent leakages.
7. Open the water tap.
45°
If the machine is exposed to
temperatures below 0°C, certain
precautions should be taken.
8.9 The Dangers Of Freezing
Turn off the water tap.1.
2. Unscrew the inlet hose.
3. Remove the drain hose from
the rear support and unhook it
from sink or spigot.
4. Put the ends of the drain and
inlet hose in a container. Let
the water flow out of the hoses.
5. When no more water flows,
install the inlet hose and the
drain hose again.
Disconnect the mains plug from
the mains socket.
Do this procedure also when you
want to do the emergency drain.
Make sure that the temperature
is more than 0 °C before you use
the appliance again.
The manufacturer is not
responsible for damages caused
by low temperatures.
Remove the water inlet hose from
the water tap.
Clean the filter in the inlet hose with
a stiff brush.