User manual

32
www.electrolux.com
The inlet hose must not be
lengthened. If it is too short and
you do not wish to move the tap,
you will have to purchase a new,
longer hose specially designed for
this type of use.
This could be done by tying it to
the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap
so that the bend is at least 60
cm above the ground.
Directly into a drain pipe at a
height of no less than 60 cm
and no more than 90 cm. The
end of the drain hose must
always be ventilated, i.e. the
inside diameter of the drain pipe
must be larger than the outside
diameter of the drain hose.
The drain hose must not be
kinked. Run it along the floor; only
the part near the drainage point
must be raised.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine.
For correct functioning of the
machine the drain hose must
remain hooked on the proper
support piece situated on the top
part of back side of the appliance.
In this case, make sure the end
cannot come unhooked when
the machine is emptying.
11.4 Water Drainage
Please check rated power
supply condition that is
mentioned on the Rating
Label before you connect
to the power supply.
“An incorrect power
supply may void your
warranty.”
Check that your domestic electrical
installation can take the maximum
load required (2.0 kW or 1.7 kW
for PHILIPPINES), also taking into
account any other appliances in
use.
If the supply cord is
damaged, should the
appliance power supply
cable need to be replaced,
this shall be carried out by
our Service Centre.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
This machine is designed to
operate on a 220-240 V, single-
phase, 50 Hz (220 V / 60 Hz for
PHILIPPINES) supply.
11.5 Electrical Connection
Connect the machine to
an earthed socket outlet.