User manual

Display
ENGLISH 9
Start/Pause Touchpad ( )
To start the selected program, press
the “Start/Pause ( )”.
To interrupt a program which is
running, press the “Start/Pause ( )”
to pause the machine, t
he Start/Pause
pilot light flashes.
To restart the program from the point
at which it was interrupted, press the
“Start/Pause ( )” again,
the Start/
Pause pilot light will stop flashing.
The display shows the following
information:
When the program is
completed the display
will show “ ”.
Incorrect Option Selection
If an option which is
not compatible with
the set wash program
selected, the display will show
“ ” and flash with 3 consecutive
short beeps.
End Of Program
In the event of operating
problems, some alarm
codes can be
displayed, for example . (see
“Troubleshooting”)
Alarm Codes
Estimated time of the selected
program
After selecting a
program, the estimated
time is displayed in
hours and minutes (for example 3.01).
The estimated time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric. After the program
has started, the time remaining is
updated every minute.
7
8
Delay End Touchpad ( )
Before you start the program, this option
makes it possible to define the end of
the washing program from minimum 3
hours to maximum 20 hours.
If program duration is longer than
3 hours minimum Delay End
option starts from 4 hours.
For example, if the program duration of
your selected program is 3.20 hours
and you define the “Delay End” time to
6 hours. This means your wash
program will finish in 6 hours. (See
diagram below)
After select Delay End time, press
Start/Pause touchpad to start the
program. Machine will then countdown
and update time on the display every
hours until it reaches the starting point
of the wash cycle.
Press the Delay End touchpad to
choose the end time as your wish. The
display shows the number of hours
and the indicator above the touchpad
is on. This option must be selected
after choosing the wash program, and
before pressing the “Start/Pause”
touchpad.
6
3.20 hrs.2.80 hrs.
Working Cycle
“Delay End” Time : 6 hrs.
Pressed
Start/Pause
End of
Cycle
Start the
Program
Countdown
NOTE:
If you wish to modify or cancel Delay
End option after starting the program,
follow the steps below:
set the washing machine to PAUSE
by pressing “Start/Pause” touchpad;
-
deselect this option by pressing
Delay End once;
-
press the “Start/Pause” to start the
program.
-