User manual

ENGLISH 17
When the program is completed
and the door lock indicator “ ”
goes off, you can open the door.
When The Washing Program
Is Completed, But There Is
Water In The Drum (Option
“Rinse Hold ” is used)
The drum turns regularly to
prevent the creases in the
laundry.
You must drain the water to open
the door.
The door lock indicator “ ” is
on. The door stays locked.
5.6
The appliance stops automatically.
The acoustic signal will operate.
The display will show “ ”.
The indicator of the “Start/Pause”
touchpad goes off.
The door lock indicator “ ”
goes off.
Remove the laundry from the
appliance. Make sure that the
drum is empty.
Keep the door and the detergent
drawer ajar, to prevent the
mildew and odours.
Turn off the water tap.
5.7 At The End Of The Program
The indicator “Start/Pause”
flashes to remind you to drain
the water.
When the program is completed
and the door lock indicator “ ”
goes off, you can open the door.
1.
To drain the water:
NOTE
Alternatively, before pressing the
“Start/Pause” touchpad, you can
press the “Spin ” touchpad to
change the spin speed. You can
select “No Spin ”, if you want
the machine to only drain the
water, then press the Start/Pause
touchpad. The appliance will drain
the water and spin.
Press the “Start/Pause ”
touchpad. The appliance
drains the water and spins with
the maximum spin speed for
selected program.
2.
Press the “On/Off” button to
deactivate the appliance.
3.
After approximately 18 hours
if you do not press
Start/Pause touchpad, the
appliance will drain and spin
automatically (except for
Wool/Handwash program) .
At the end of the program
the time remaining can
suddenly decrease from 7
minutes or less to 0 due to
the overestimated total
program time during the load
sensing phase.
In some cases (with perfectly
balanced load) the program
time can be shorter than the
time estimated after the load
sensing phase is completed.
This is a normal behavior of
the machine and not a cause
for concern as it does not
compromise its performance.