User manual

ENGLISH 9
If you set also the Rinse Plus function ( )
the appliance adds two rinses.
Display
With this option you can perform only a
last rinse of a selected washing program.
If you set also the “No Spin ” option,
the appliance only drains.
Rinse & Spin
Use this option for very wet clothes to
remove the water and spin.
Drain & Spin
Start/Pause Touchpad ( )
To start the selected program, press
the “Start/Pause ( )”.
To interrupt a program which is
running, press the “Start/Pause ( )”
to pause the machine, t
he Start/Pause
pilot light flashes.
To restart the program from the point
at which it was interrupted, press the
“Start/Pause ( )” again,
the Start/
Pause pilot light will stop flashing.
The display shows the following
information:
Estimated time of the selected
program
After selecting a
program, the estimated
time is displayed in
hours and minutes (for example 3.01).
The estimated time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric.
7
8
Any temperature may be
selected, but COLD ( ) water
is recommended with this cycle
as hotter water may set some
stains.
Use the amount of detergent recom-
mended for a normal wash cycle. If
desired, use a bleach or a soaking agent
safe for the fabric, by pouring it into the
detergent compartment.
If you set also the “No Spin ” option,
the appliance only rinse.
Delay End Touchpad ( )
Before you start the program, this option
makes it possible to define the end of the
washing program from minimum 3 hours to
maximum 20 hours.
If program duration is longer than 3
hours minimum Delay End option starts
from 4 hours.
For example, if the program duration of your
selected program is 3.20 hours and you
define the “Delay End” time to 6 hours. This
means your wash program will finish in 6
hours. (See diagram)
After select Delay End time, press
Start/Pause touchpad to start the
program. Machine will then countdown
and update time on the display every
hours until it reaches the starting point
of the wash cycle.
Press the Delay End touchpad to choose
the end time as your wish. The display
shows the number of hours and the
indicator above the touchpad is on. This
option must be selected after choosing the
wash program, and before pressing the
“Start/Pause” touchpad.
6
3.20 hrs.2.80 hrs.
Working Cycle
“Delay End” Time : 6 hrs.
Pressed
Start/Pause
End of
Cycle
Start the
Program
Countdown
NOTE:
If you wish to modify or cancel Delay
End option after starting the program,
follow the steps below:
set the washing machine to PAUSE
by pressing “Start/Pause” touchpad;
-
deselect this option by pressing
Delay End once;
-
press the “Start/Pause” to start the
program.
-