Installation Guide

WARNING

ELECTRICALSHOCKHAZARD

Failure to disconnect power source before servicing

could result in personal injury or even death.

B)RemovingDoorfromHinge

1 Reopen door to 90 degree angle.

2 Remove 4 long, course-thread, counter-sunk

hinge screws from door.

A) Removing Trim Ring

1 Open the door to a 90 degree angle.

2 Remove and save the trim plug and long,

course-thread, panhead screw.

3 Close the door.

4 Rotate the door trim approximately ¾”

counter-clockwise and pull it away from the

front of the door.

3 While supporting the weight of the door

with both hands, separate the door from the

hinge.

 4 Gentlyplacethedoorfacedownonaat,

covered work surface.

Reversing Door

Removing door and hardware

1 Be sure you have adequate swing area before reversing door.

2 You will need a screw driver with a #2 square bit.

3 Protect ﬂat work surface, such as top of washer or ﬂoor near

washer, with a soft cloth or towel.

4 Be sure washer is unplugged from power source!

Preparing to reverse door swing

Screwdrivers with

#2 square &

straight bit

Tools needed: