Installation Instructions

ManualsBrandsElectrolux ManualsHousehold ApplianceWave-Touch 4.4 cu. ft. High-Efficiency Front Load Washer with Steam in Island White, ENERGY STAR

If your washer has this console: If your washer has this console:

1. Empty washer’s drum and close door.

2. After you plug in the washer the ﬁ rst time: wake up

the washer by pressing any button, rotate cycle knob

to cycle one up from lower right position (1), press the

start button (3) and then the cancel button (4).

3. Wake up the washer again by pressing any button,

then immediately and simultaneously press and hold

buttons 2a and 2b for 5 seconds, or until the LCD

display changes.

4. The LCD window will display INSTAL CYCLE and

show estimated time of cycle completion. Press the

start button (3). The Installation Cycle will automati-

cally perform various diagnostic routines. At cycle

completion, the LCD window may display INSTAL

PASS!, meaning your new washer is properly installed

and ready for use. If it prompts an action such as NO

WATER, CHECK HOSES or CALL SERVICE

877 435 3287, review the installation steps and

make the necessary corrections before you attempt to

use the washer.

5. Your washer will exit the Installation Cycle and return

to normal operation the next time you wake it up.

6. Please read the Use & Care Guide and enjoy your new

premium washer!

1. After you plug in the washer the ﬁ rst time: wake up

the washer by pressing any button and then follow the

prompts on the LCD User Interface, including lan-

guage selection.

2. The Installation Cycle will automatically perform vari-

ous diagnostic routines. At cycle completion, the LCD

window may display INSTAL PASS!, meaning your

new washer is properly installed and ready for use. If

it prompts an action such as NO WATER, CHECK

HOSES or CALL SERVICE 877 435 3287,

review the installation steps and make the necessary

corrections before you attempt to use the washer.

3. Your washer will exit the Installation Cycle and return

to normal operation the next time you wake it up.

4. Please read the Use & Care Guide and enjoy your new

premium washer!

Performing Installation Cycle

NOTE

Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately run the washer

through a washing cycle, press the cancel button to put the unit to sleep and then rewake it immediately

to continue the normal operating mode.

With your washer in ﬁ nal location, perform an Installation Cycle to assist in proper installation.