Installation Instructions

Leveling your washer

Excessive noise and vibration can be prevented by

properly leveling the washer.

1. For free standing installation and with the washer

within 4 feet (1 m) of its ﬁ nal location, place a level

on top of the washer.

2. Use the universal wrench to adjust the leveling

legs so the washer is level front-to-rear and side-

to-side, and stable corner-to-corner.

3. Press down on alternate corners and sides and

feel for the slightest movement. Adjust the appro-

priate leg(s) so the washer sits solidly on the ﬂ oor

on ALL four legs. Keep the leveling leg extension

at a minimum for best performance of the washer.

NOTE

For pedestal installations, see additional installation

instructions included with the pedestal.

NOTE

Hoses are not included with washer purchase. See

“Accessories” section for various inlet hose kits to ﬁ t

your speciﬁ c installation.

Connecting inlet water

1. Run some water from the hot and cold faucets to

ﬂ ush the water lines and remove particles that might

clog the water valve screens and to determine which

faucet is hot and which is cold supply.

2. Connect the HOT inlet hose to the HOT inlet con-

nection on the washer and the COLD inlet hose to

the COLD inlet connection on the washer. Tighten by

hand until snug. Then tighten each supply connec-

tion another 2/3 turn with pliers. Do not cross thread

or over-tighten these connections.

3. Connect the HOT inlet hose to the HOT water supply

and the COLD inlet hose to the COLD water supply.

Tighten by hand until snug. Then tighten each supply

connection another 2/3 turn with pliers. Do not bend,

kink or pinch water inlet hoses.

4. Turn on the water and check for leaks.

raise

lower

COLD

HOT

RUBBER WASHERS

MUST BE PRESENT

USE ONLY NEW

HOSES