User manual

C
b) Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth 12.5-14 mm
depending on the depth of door furniture)
on the inner side of the door. The distance
between the holes hobs fixing centres must
be 416 mm.
The distance (B) from upper edge of the
door to the centre of the hole depends on
the adjacent furniture's dimensions.
The required dimensions are given in the
picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B) sup-
plied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means
of the M 5x15 screws (3-Fig. B). The hinges
can be adjusted to compensate for possi-
ble uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door
and tighten the screw again.
d) Counter-magnet (6)
The appliance is prearranged for a magnet-
ic closure of the door.
To enable a correct operation of this device,
it is necessary to screw the counter-magnet
(6) (steel disk + rubber ring) into the inner
side of the door. Its position must corre-
spond to the magnet (4) on the appliance
(see picture D).
D
6
4
If the door has to be opened from left to
right, invert the position of the plates (7), the
magnet (4) and the plate (5) (Fig. B and E).
Mount the counter-magnet (6) and the hing-
es (1) as previously described.
E
1
2
3
7
6
5
4
ELECTRICAL CONNECTION
Information on the electrical connection is
given on the rating plate on the inner edge
of the appliance door.
Check that your domestic electrical installa-
tion can take the maximum load required,
also taking into account any other applian-
ces in use.
electrolux 27