User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. PRODUCT DESCRIPTION
- 4. CONTROL PANEL
- 5. PROGRAMME CHART
- 6. CONSUMPTION VALUES
- 7. OPTIONS
- 8. SETTINGS
- 9. BEFORE FIRST USE
- 10. DAILY USE
- 10.1 Loading the laundry
- 10.2 Using detergent and additives
- 10.3 Detergent compartments
- 10.4 Liquid or powder detergent
- 10.5 Setting a programme
- 10.6 Starting a programme without the delay start
- 10.7 Starting a programme with the delay start
- 10.8 Interrupting a programme and changing the options
- 10.9 Cancelling a programme
- 10.10 Opening the door when the delay start operates
- 10.11 Opening the door when the programme operates
- 10.12 At the end of the programme
- 10.13 Stand-by
- 11. HINTS AND TIPS
- 12. CARE AND CLEANING
- 13. TROUBLESHOOTING
- 14. TECHNICAL DATA
You can cancel or change
the set of the delay start
before you press the
. To
cancel the delay start:
•
Press
to set the
appliance to pause.
•
Press
until the display
shows '.
•
Press
again to start
the programme
immediately.
10.8 Interrupting a programme
and changing the options
You can change only some options before
they operate.
1. Press
.
The indicator flashes.
2. Change the options.
3. Press again.
The programme continues.
10.9 Cancelling a programme
1. Turn the programme knob to position
to cancel the programme and to
deactivate the appliance.
2. Turn the programme knob again to
activate the appliance. Now, you can
set a new washing programme.
The appliance does not drain
the water.
10.10 Opening the door when
the delay start operates
While the delay start operates, the
appliance door is locked and the display
shows the indicator .
CAUTION
If the temperature and level of
the water in the drum are too
high, you cannot open the
door.
1. Press to pause the appliance.
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press
again.
The delay start continues to operate.
10.11 Opening the door when
the programme operates
While a programme operates, the
appliance door is locked and the indicator
is on.
CAUTION
If the temperature and level of
the water in the drum are too
high, you cannot open the
door.
1. Turn the programme knob to position
to deactivate the appliance.
2. Wait for some minutes and then open
the appliance door.
3. Close the appliance door.
4. Set the programme again.
10.12 At the end of the
programme
• The appliance stops automatically.
•
The acoustic signal operates (if it is
activated).
• In the display
comes on.
•
The indicator of the
goes off.
•
The door lock indicator
goes off.
•
You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Turn the programme knob to position
to deactivate the appliance.
•
Keep the door ajar, to prevent the
mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The door lock indicator
is on. The
indicator flashes. The door stays
locked.
•
You must drain the water to open the
door.
www.electrolux.com14