user manual Washing Machine Downloaded From WashingMachine-Manual.
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 Centre. Always insist on genuine spare parts. INSTALLATION • This appliance is heavy. Care should be taken when moving it. • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • This appliance is free standing only. DO NOT build it in under a counter and DO NOT remove the worktop for any reason.
electrolux • • • • struction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. The packaging components (e.g. plastic film, polystyrene) can be dangerous to children - danger of suffocation! Keep them out of children’s reach. Keep all detergents in a safe place out of children’s reach. Make sure that children or pets do not climb inside the drum.
electrolux 5 This means that they can be recycled by disposing of them properly in appropriate collection containers. ECOLOGICAL HINTS To save water, energy and to help protect the environment, we recommend that you follow these tips: • Normally soiled laundry may be washed without prewashing in order to save detergent, water and time (the environment is protected too!). • The machine works more economically if it is fully loaded.
electrolux Spin Speed Maximum 1000 rpm (EWP 106300W) 1200 rpm (EWP 126300W) 1) Connect the water inlet hose to a water tap with a 3/4'' thread. INSTALLATION UNPACKING Warning! • Read carefully the "Safety information" chapter before installing the appliance. Warning! Remove and keep all transit devices so that they can be refitted if the appliance ever has to be transported again. • Remove the polystyrene base from the bottom.
electrolux 7 • Remove the power supply cable and the draining and inlet hose from the hose holders (C) on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. • Unscrew the three bolts (A) and remove the hose holders (C). • Slide out the relevant plastic spacers (B). POSITIONING AND LEVELLING Level the appliance by raising or lowering the feet.
electrolux 45° 35° • After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Accurate levelling prevents vibration, noise and displacement of the appliance during operation. Repeat the levelling action, if the appliance is not level and stable. WATER DRAINAGE Form a hook at the end of the drain hose using the plastic hose guide, if necessary. The end of the drain hose can be positioned in four ways: • Hooked over the edge of a sink using the plastic hose guide.
electrolux 9 • Directly to a built-in drain pipe in the room wall. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose to prevent waste from the sink entering the appliance. If the outlet spigot has not been used before, remove any blanking plug that may be in place. • Directly into a drain pipe at a height of not less than 60 cm and not more than 100 cm. The end of the drain hose must always be ventilated, i.e.
electrolux CONNECTIONS OVERVIEW 115 cm 140 cm 115 cm 90 cm max 100 cm min. 60 cm max 100 cm 100 cm ELECTRICAL CONNECTION • The appliance must be earthed. • Make sure that the electrical information on the rating plate agree with your domestic power supply. • Always use a correctly installed shockproof socket. • Do not use multi-way plugs, connectors and extension cables. There is a risk of fire. • Do not replace or modify the mains cable yourself. Contact the After Sales Service. 150 cm min.
electrolux 11 PERSONALISATION BUZZER The appliance is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle; • if there is a fault. By pressing the 2 and 3 buttons simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated. cause damage to the appliance. This function remains enabled also when the appliance is not working.
electrolux Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone2), lay the garment on a soft cloth and dab the stain.
electrolux 13 SH DOWN - Flap position if using LIQUID detergent during main wash RE TO MOV CL E EA N OPEN THE DETERGENT DISPENSER DRAWER Compartment for powder or liquid detergent used for main wash. Compartment for liquid additives (fabric softener, starch). RE TO MOV CL E EA N DEGREES OF WATER HARDNESS Water hardness is classified in so-called “degrees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority.
electrolux D UID LIQ NT R GE l ETE 120m l 60m • Measure out the detergent. • Remove the drawer. Push the drawer edge outwards where indicated by the arrow (PUSH) to facilitate drawer removal. The flap is down and you wish to use powder detergent: • Rotate the flap upwards. Ensure to fit the flap completely in. • Carefully put the drawer back.
electrolux 15 compartments of the dispenser drawer just before starting the wash programme. CLOSE THE DETERGENT DISPENSER DRAWER SET YOUR WASHING PROGRAMME The control panel permits to select a washing programmes and different options. When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programmes".
electrolux • To switch the appliance off, turn the programme selector dial to the position . • To cancel or change a running programme, switch the appliance off by turning the programme selector . Select the new programme by dial to the position turning the selector to the desired programme. Start the new programme by pressing the button 8 again. The water in the tub will be not emptied out.
electrolux 17 5 Display 5.1 5.2 5.3 6 Delay Start The display shows the following information: 5.1 Delay Start icon 5.2 Child safety lock This device permits you to leave the appliance unattended during it's functioning. 5.3 • Duration of the selected programme After selecting a programme, the duration is displayed ). The durain hours and minutes (for example tion is calculated automatically on the basis of the maximum recommended load for each type of fabric.
electrolux Cancelling the Delay Start after having started the programme: • Set the appliance to PAUSE by pressing button 8. • Press button 6 once. On the display will appear '. • Press button 8 again to start the programme. • The selected delay can be changed only after selecting the washing programme again. • The door will be locked throughout the delay time. If you need to open the door, you must first set the appliance to PAUSE by pressing button 8 and wait a few minutes before opening the door.
electrolux 19 AT THE END OF THE PROGRAMME The appliance stops automatically. The pilot light of the button 8 and the pilot light 7.3illuminates. The display shows a zero. If a programme or an option that ends with water left in the tub has been selected, the door is locked to indicate that the water must be emptied out before opening the door. Follow the below instructions to empty out the water: • Turn the programme selector dial to . • Select the draining or spinning programme.
electrolux Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options COTTON ECONOMY 60° - 40° Main wash - Rinses - Maximum spin speed: 1000 rpm for model EWP 106300W (1200 rpm for model EWP 126300W) Max. load 6 kg White and coloured cotton. This programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended.
electrolux 21 Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry RINSE Rinse - Short spin speed 700 rpm. If a spin speed higher than 700 rpm is selected, by pressing the relevant button, the appliance performs a long spin. (Maximum spin speed: 1000 rpm for model EWP 106300W (1200 rpm for model EWP 126300W) Max. load 6 kg To rinse and spin cotton garments which have been washed by hand.
electrolux Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Detergent Compartment Options SPIN REDUCTION, RINSE HOLD, DELAY START JEANS (Cold) 60°Main wash - Rinses - Maximum spin speed: 1000 rpm for model EWP 106300W (1200 rpm for model EWP 126300W) Max. load 3 kg Trousers, shirts or jackets in denim and jersey realized with hi-tech materials. The Extra Rinse option is activated automatically.
electrolux 23 • To aid cleaning, the top part of the additive compartment should be removed. • Use the previous brush to clean the recess, ensuring that upper and lower part of it is well cleaned. • Use a stiff brush to clean and remove all washing powder residue. • Clean all the removed parts of the dispenser drawer under a tap to remove any traces of accumulated powder. After having cleaned the dispenser and the drawer recess, replace it.
electrolux • Open the filter cover by pressing the special hook and by rotating the cover upwards.; • Remove the filter and clean it under the tap. Warning! Keep the filter cover open until the filter removal. • Before removing the filter, remove any fluff or small objects from around the filter. • If necessary, place the filter cover in the right position again. • Open the filter cover and insert the filter again. Downloaded From WashingMachine-Manual.
electrolux 25 CLEANING THE WATER INLET FILTERS Important! If the appliance doesn't fill, it takes a long time to fill with water, the starting button flashes red or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush.
electrolux WHAT TO DO IF… The appliance does not start or stops during operation. Certain problems are due to lack of simple maintenance or oversights, which can be solved with the help of the indications described in the charts, without calling out an engineer. During appliance operation it is possible that the red pilot light of the button 8 flashFault code and malfunction es, the display shows a fault code and the buzzer sounds to indicate that the appliance is not working.
electrolux 27 The door has not been closed or is not closed properly. • Close firmly the door. Door open The appliance does not start or stops during operation without any visible alarm. Malfunction The appliance does not start: The appliance fills then empties immediately: Before contacting your local Service Centre, please carry out the checks listed below. Possible cause / Solution The plug is not properly inserted in the power socket. • Insert the plug into the power socket.
electrolux Malfunction Possible cause / Solution The appliance vibrates noisily: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. • Adjust the feet. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry.
electrolux 29 Downloaded From WashingMachine-Manual.
electrolux Downloaded From WashingMachine-Manual.
electrolux 31 Downloaded From WashingMachine-Manual.
www.electrolux.com/shop Downloaded From WashingMachine-Manual.
