User manual

16 www.electrolux.com
To pause press Start/ Pause. The
indicator will start flashing.
-
Press the Start/Pause again. The
program will continue.
-
5.2 Interruption Of A Program
5.3 Changing A Program
It is possible to change only some option
after the program has started.
Press the touchpad Start/Pause.
The indicator will start flashing.
1.
Change the options.2.
Press Start/Pause again. The program
will continue.
3.
While a program or the delay start is
operating, the appliance door is locked
and the display shows the indicator ‘ ’.
5.4 Changing The Options
5.5 Opening The Door
First set the machine to PAUSE by
pressing the “Start/Pause” touchpad.
Wait until the door lock indicator ‘ ’
goes off, then the door can be opened.
If the door lock indicator ‘ ’ does not
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or
the drum is turning. In this case the door
CAN NOT be opened.
If you can not open the door but you
need to open it you have to switch
the machine off by turn the program
selector knob to the position ‘ ’ to
deactivate the appliance. After about
5 minutes the door can be opened.
Pay attention to the water
level and water temperature.
CAUTION!
The appliance stops automatically.
The acoustic signal will operate.
The display will show ‘ ’ (display
models) or Washing End ‘ ’
pilot lights come on (none-display
models).
The indicator of the Start/Pause
touchpad goes off.
-
-
-
-
-
-
-
-
The door lock indicator ‘ ’
goes off.
Remove the laundry from the
appliance. Make sure that the
drum is empty.
Keep the door ajar, to prevent
the mildew and odours.
Turn off the water tap.
5.6 At The End Of The Program
1.
2.
When The Washing Program
Is Completed, But There Is
Water In The Drum
The drum turns regularly to prevent
the creases in the laundry.
You must drain the water to open
the door.
The door lock indicator ‘ ’ is
on. The door stays locked.
To drain the water:
If necessary, decrease the spin
speed.
Set the “Spin” or “Drain” program.
-
-
5.7
Changing a running program is possible
only by resetting it.
Turn the program selector knob to the
position ‘ ’ to cancel the program
and to turn off the appliance.
1.
Turn the program selector knob to the
new program position and set the new
option, then press ‘Start/Pause’
touchpad again.
The appliance will not drain the
water.
2.