User manual

Press the related button to set the new val-
ue.
Set the delay start
1. Press the delay start button again and
again until the display shows the num-
ber hours.
2. Press the start button, the appliance
starts the countdown of the delay start.
The symbol h flashes in the display and
the start button indicator is off.
When the countdown is completed, the
programme starts automatically and
the start button indicator comes on.
You can cancel or change the set of
the delay start also when the appliance
starts the countdown.
Cancel the delay start
Press the delay start button again and
again until the display shows 0.
The programme starts and the start button
indicator comes on.
Open the door
While a programme operates, the appliance
door is locked.
To open the appliance door:
1.
Turn the programme knob to
to de-
activate the appliance.
2. Wait for some minutes before to open
the appliance door.
3. Close the appliance door.
4. Set the programme again.
If the temperature and level of the wa-
ter in the drum are too high, you can-
not open the door.
To open the appliance door:
• Do the steps 1 and 2 again.
• Wait for some minutes.
• Make sure that no water is in the
drum.
At the end of the programme
• The appliance stops automatically.
• The display shows the End symbols.
•
Turn the programme knob to
to deac-
tivate the appliance.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is completed,
but there is water in the drum:
– The Rinse Hold function or a programme
that stops with water in the drum is set.
– The door stays locked and the start but-
ton indicator flashes.
– You must drain the water before to open
the door.
To drain the water:
1. If necessary, decrease the spin speed.
2. Press the start button. The appliance
drain the water and spin.
3. When the programme is completed:
– The display shows the End symbols.
– You can open the door.
4.
Turn the programme knob to
to de-
activate the appliance.
CARE AND CLEANING
Warning!
Disconnect the appliance from the mains
supply before you clean it.
External cleaning
Clean the appliance only with soap and
warm water. Fully dry all the surfaces.
Caution! Do not use alcohol, solvents
or chemical products.
Descaling
The water we use contains limescale. If it
becomes necessary, use a water softener
to remove limescales.
Use a special product made for washing
machines. Obey the instructions that you
find on the packaging of the manufacturer.
Do this separately from the laundry wash.
Maintenance wash
With the low temperature programmes it is
possible that some detergent stays in the
electrolux 11