User manual

Before starting the new
programme the appliance
drains the water. Make sure
that the detergent is still in
the detergent compartment, if
not fill the detergent again.
10.11 Opening the door when
the delay start operates
While the delay start operates, the
appliance door is locked and the display
shows the indicator .
1. Press to pause the appliance.
2. Wait until the door lock indicator
goes off.
3. Open the door.
4. Close the door.
5. Press
again.
The delay start continues to operate.
10.12 Opening the door when
the programme operates
While the programme operates, the
appliance door is locked and the display
shows the indicator .
CAUTION!
If the temperature and level of
the water in the drum are too
high, you cannot open the
door.
1. Press the button for some seconds
to deactivate the appliance.
2. Wait for some minutes and then open
carefully the appliance door.
3. Close the appliance door.
4. Set the programme again.
10.13 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display comes on.
• The indicator of the goes off.
• The door lock indicator goes off.
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Close the water tap.
• Press the button for some seconds
to deactivate the appliance.
• Keep the door ajar, to prevent the
mildew and odours.
The washing programme is
completed, but there is water in the
drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The door lock indicator is on. The
door stays locked.
• You must drain the water to open the
door.
To drain the water:
1. Press . The appliance drains the
water and spins.
2. To make the appliance drain only, set
. If necessary, decrease the
spin speed.
3. When the programme is completed
and the door lock indicator goes
off, you can open the door.
4. Press the button for some seconds
to deactivate the appliance.
The appliance drains and
spins automatically after
approximately 18 hours
(except for Wool programme).
10.14 AUTO Stand-by option
The AUTO Stand-by option automatically
deactivates the appliance to decrease the
energy consumption when:
• You do not use the appliance for 5
minutes before you press
.
Press the button to activate the
appliance again.
• After 5 minutes from the end of the
washing programme
Press the button to activate the
appliance again.
The display shows the end of the last
set programme.
Turn the programme knob to set a new
cycle.
ENGLISH
15