User manual

ENGLISH
7 Rinse hold button
When you choose this option, the machine will not
drain the water of the last rinse, so as not to wrinkle
the laundry. At the end of the programme, the light
of the START/PAUSE button goes off, the pilot lights
and
remain lit, to indicate that the water must be
drained. To empty out water there are 2 possibilities:
• Select programme B (draining): The water is
emptied out without spinning.
• Select programme C or D. Selest the spin speed
by means of the relevant button and then depress
the START/PAUSE button. The water is emptied
out and the laundry is spun at the selected spin
speed.
Attention!
Before choosing the programme
B
,
C or D
the selector dial has to be positioned on «0»
(cancelling).
8 Quick wash button
This option can be used for lightly soiled items (not
for wool, hand wash) in order to obtain a good
washing program in a short time. The washing time
will be reduced according to the type of fabric and
the selected temperature.
9 Super rinse button
This option can be selected with all programmes,
except the wool programme and handwash. The
machine will add 2 rinses to the selected program.
This option is recommended for people who are
allergic to detergents and in areas where the water is
very soft.
10 SENSITIVE button
Can be used with all cotton and synthetic
programmes. Adds one rinse to rinsing phase and
reduces or eliminates the intermediate spin phases.
11 DELAY START button
The wash programme can be delayed from 30 min –
60 min – 90 min, 2 hours and then by 1 hour up to a
maximum of 23 hours by means of this button.
Selecting the delayed start
• Select the programme and the required options.
• Select the delay start.
• Depress START/PAUSE button: the machine starts
its hourly countdown.
The programme will start after the selected delay
has expired.
Altering the delayed start
• Depress START/PAUSE button .
• Depress DELAY START button until the
required time is displayed: the symbol 0’ is
displayed.
• Depress START/PAUSE button again
12 Display
The display shows the following information:
Cancelling – Duration of the programme –
Delayed start – Incorrect option selection – Alarm
code – End of programme.
If a programme has been cancelled – programme
selector dial on position 0 – display and all the lights
are off.
After selecting a programme, the duration is
displayed in hours and minutes (for example 2.05).
The duration is calculated automatically on the basis
of the maximum recommended load for each type of
fabric.
After the programme has started, the time remaining
is updated every minute.
The selected delay (23 hours max) set by means
of the relevant button appears on the display for
3 seconds, then the duration of the previously
selected programme is displayed.
The countdown is updated every hour.
Delayed start
2.05
Duration of the selected programme
Cancelling
9
132990760 GB.qxd 19/04/2004 11.26 Pagina 9