EWS 1276 CDU EN Washing Machine User Manual
www.electrolux.com CONTENTS 1. SAFETY INFORMATION....................................................................................3 2. SAFETY INSTRUCTIONS..................................................................................4 3. PRODUCT DESCRIPTION................................................................................ 5 4. CONTROL PANEL............................................................................................. 6 5. PROGRAMMES ....................................
ENGLISH 1. 3 SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.
www.electrolux.com • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects. 2.
ENGLISH • • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. The first time you use the appliance, make sure that there is no leakage. 2.4 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance. • • • • • • 2.5 Disposal Use this appliance in a household only. Obey the safety instructions on the detergent packaging.
www.electrolux.com 4. CONTROL PANEL 4.
ENGLISH 4.2 Display A G B C F E A. The Temperature area: • : Temperature indicator • : Cold water indicator • B. : Time Manager indicator. C. The time area: • • D : the washing phase : the rinses phase : the spin phase : the Extra rinse permanent option. F. The spin area: • : the programme duration : the delay start • : the Spin speed indicator • : the alarm codes • : the No Spin indicator • : the message of error • : the Rinse Hold indicator • : the programme is completed. D.
www.electrolux.com Programme Temperature range Syntetiké 60°C - Cold Jemné 40°C - Cold Vlna/Ruční Pra‐ ní 40°C - Cold Jeans 60°C - Cold Máchání Odstřeďování/ Vypouštění3) Spodní Prádlo 40°C - Cold Hedvábí 30°C Záclony 40°C - Cold Lůžkoviny 60°C - 30°C Osvěžení 30°C Maximum load Maximum spin speed Programme description (Type of load and soil level) 3 kg 1200 rpm Synthetic items or mixed fabric items. Normal soil. 3 kg 1200 rpm Delicate fabrics as acrylics, viscose, polyest‐ er items. Normal soil.
ENGLISH Programme Temperature range Krátký 30°C 9 Maximum load Maximum spin speed Programme description (Type of load and soil level) 1 kg 800 rpm Synthetic and mixed fabric items. Light soil and items to freshen up. 1) Standard programmes for the Energy Label consumption values. According to regu‐ lation 1061/2010, these programmes are respectively the «Standard 60°C cotton pro‐ gramme» and the «Standard 40°C cotton programme».
www.electrolux.com Programme Krátký ■ ■ ■ 1) Set the spin speed. Make sure it agrees with the laundry. If you set No Spin option the only drain phase is available. 6. CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient tempera‐ ture. At programme start the display shows the duration programme for the maximum load capacity.
ENGLISH Off Mode (W) Left On Mode (W) 0,48 0,48 11 The information given in the chart above are in compliance with the EU Commission regulation 1015/2010 implementing directive 2009/125/EC. 7. OPTIONS 7.1 Teplota • Set this option to change the default temperature. • = cold water. Indicator The display shows the set temperature. • 7.2 Odstředění • The display shows the indicator of the set speed. • Set this option to remove all spin phases. Set it for very delicate fabrics.
www.electrolux.com The appliance decreases the spin speed, uses more water and adapts the programme duration to the type of laundry. The related indicator comes on. In‐ di‐ ca‐ tor 1) 7.7 Time Manager ■ ■ When you set a washing programme, the display shows the default duration. ■ ■ ■3) ■3) ■ ■ ■ ■ Press or to decrease or increase the programme duration. The Time Manager is available only with the programmes in the table.
ENGLISH 13 9. BEFORE FIRST USE 1. Put 2 litre of water in the detergent compartment for washing phase. This activates the drain system. 2. Put a small quantity of detergent in the compartment for washing phase. 3. Set and start a programme for cotton at the highest temperature without laundry. This removes all possible dirt from the drum and the tub. 10. DAILY USE WARNING! Refer to Safety chapters. 2 1 10.1 Loading the laundry 1. Open the appliance door 2.
www.electrolux.com 10.4 Liquid or powder detergent A 1. 2. B 3. 4. • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid then the maximum level. • Do not set the prewash phase. • Do not set the delay start. 10.5 Activating the appliance Press the button to activate or deactivate the appliance. A tune sounds when the appliance is activated. 10.
ENGLISH • The indicator of and stays on. • The indicator starts to flash on the display. The programme starts, the door locks, the display shows the • • stops to flash indicator . The drain pump can operate for a short time when the appliance fills water. After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the programme duration agree with the laundry load. • The display shows the new value. 10.8 Starting a programme with the delay start 1.
www.electrolux.com CAUTION! If the temperature and level of the water in the drum are too high, you cannot open the door. 1. Press the button for some seconds to deactivate the appliance. 2. Wait for some minutes and then open carefully the appliance door. 3. Close the appliance door. 4. Set the programme again. • In the display The indicator of the • • • The door lock indicator goes off. You can open the door. Remove the laundry from the appliance. Make sure that the drum is empty.
ENGLISH • • • • • • Turn inside out multilayered fabrics, wool and items with painted illustrations. Remove hard stains. Wash with a special detergent heavy soil stains. Be careful with the curtains. Remove the hooks or put the curtains in a washing bag or pillowcase. Do not wash in the appliance laundry without hems or with cuts. Use a washing bag to wash small and/or delicate items (e.g. underwired bras, belts, tights, etc. ). A very small load can cause balance problems with the spin phase.
www.electrolux.com 12.2 Descaling the drum. Make regularly a maintenance wash. To do this: If the water hardness in your area is high or moderate, we recommend that you use a water descaling product for washing machines. • • Regularly examine the drum to prevent limescale and rust particles. Remove the laundry from the drum. Set the cotton programme with the highest temperature with a small quantity of detergent. 12.
ENGLISH 5. 6. 12.6 Cleaning the inlet hose and the valve filter 1. 2. 3. 4. 12.7 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot.
www.electrolux.com 1. 2. 3. 4. 5. 6. 1 7. 2 8.
ENGLISH 9. 21 10. 2 1 12.8 Emergency drain Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (9) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. When you drain the water with the emergency drain procedure, you must activate again the drain system: Put 2 litres of water in the main wash compartment of the detergent dispenser. 2.
www.electrolux.com • - The mains supply is unstable. Wait until the mains supply is stable. WARNING! Deactivate the appliance before you do the checks. 13.2 Possible failures Problem Possible solution The programme does not start. Make sure that the mains plug is connected to the mains socket. Make sure that the appliance door is closed. Make sure that there is not a damaged fuse in the fuse box. Make sure that the Start/Pause has been pressed.
ENGLISH Problem 23 Possible solution The spin phase does Set the spin programme. not operate or the washing cycle lasts lon‐ ger than usually. Make sure that the drain filter is not clogged. Clean the fil‐ ter, if necessary. Refer to 'Care and cleaning'. Adjust manually the items in the tub and start the spin phase again. This problem may be caused by balance problems. There is water on the floor. Make sure that the couplings of the water hoses are tight and there is not water leakages.
www.electrolux.com 14.
ENGLISH 25
www.electrolux.
ENGLISH 27
155248941-A-072016 www.electrolux.
