EWS 1476 EDU ................................................ .............................................
www.electrolux.com CONTENTS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 PRODUCT DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ENGLISH 3 1. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety WARNING! Risk of suffocation, injury or permanent disability.
www.electrolux.com • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • The operating water pressure (minimum and maximum) must be between 0,5 bar (0,05 MPa) and 8 bar (0,8 MPa) • The ventilation openings in the base (if applicable) must not be obstructed by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. 2.
ENGLISH Water connection • Make sure not to cause damage to the water hoses. • The appliance is to be connected to the water mains using the new supplied hose-sets. Old hose sets must not be reused. • Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. • The first time you use the appliance, make sure that there is no leakage. 2.2 Use WARNING! Risk of injury, electrical shock, fire, burns or damage to the appliance.
www.electrolux.com 3. PRODUCT DESCRIPTION 1 2 3 1 Worktop 2 Detergent dispenser 3 Control panel 4 Door handle 5 Drain pump filter 6 Rating plate 4 7 Feet for the appliance level 5 6 7 4.
ENGLISH 4.1 Display A G B C F E A) The Temperature area: B) – : the spin phase : Temperature indicator – : the steam phase : Cold water indicator – : Extra rinse permanent option. F) The spin area: – : the Spin speed indicator : Time Manager indicator. C) The time area: – – : the delay start : the alarm codes – : the message of error G) : Programme is completed. D) : the child safety lock indicator.
www.electrolux.com Programme Temperature range Synthetics ( Synthetics ) 60° C - Cold Delicates ( Delicates ) 40 °C - Cold Wool/Handwash ( Wool/Handwash ) 40 °C – Cold Jeans ( Jeans ) 60 °C – Cold Rinse ( Rinse ) Cold Spin / Drain ( Spin/Drain ) Lingerie ( Lingerie ) 40 °C – Cold Silk ( Silk ) 30 °C Curtains ( Curtains ) 40 °C - Cold Bedding ( Bedding ) 60° C - 30° C Refresh ( Refresh ) 30 °C Quick ( Quick ) 30 °C Type of load and soil Maximum load, Maximum spin Synthetic items or mixed fabric items.
ENGLISH 9 efficient programmes in terms of combined energy and water consumption for washing normally soiled cotton laundry. The water temperature of the washing phase may differ from the temperature declared for the selected programme. 2) Do not use any detergent for prewash phase.
www.electrolux.com 6. CONSUMPTION VALUES At programme start the display shows the duration programme for the maximum load capacity. During the washing phase the programme duration is automatically calculated and can greatly be reduced if the laundry load is lower than the maximum load capacity (e.g. Cotton 60°C, maximum load capacity 7 kg, the programme duration exceeds 2 hours; real load 1 kg, the programme duration don’t reach 1 hour).
ENGLISH 11 7. OPTIONS 7.1 Temperature 7.3 Prewash Set this option to change the default temperature. Indicator = cold water. The indicator of the set temperature comes on. With this option you can add a prewash phase to a washing programme. Use this option for heavy soil. When you set this option the programme duration increases. The related indicator comes on. With this option you can decrease the default spin speed. The display shows the indicator of the set speed.
Indicator 12 www.electrolux.com 3) ■ ■ ■ ■ ■ ■ ■2) ■2) ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■2) ■ ■ ■2) ■2) ■ ■2) 1) Shortest: to fresh the laundry. 2) Programme default duration. 3) Longest: Increasing the programme duration gradually decreases the energy consumption. The optimized heating phase saves energy and the longer duration maintains the same washing results (specially for normal soil).
ENGLISH 13 9.1 Loading the laundry 1. 2. 3. Open the appliance door. Put the laundry in the drum, one item at a time. Shake the items before you put them in the appliance. Make sure not to put too much laundry in the drum. Close the door. CAUTION! Make sure that no laundry stays between the seal and the door. There is a risk of water leakage or damage to the laundry. 9.2 Using detergent and additives 2 1 • Measure out the detergent and the fabric conditioner. • Carefully close the detergent drawer.
www.electrolux.com 3. 4. B • Position A for powder detergent (factory setting). • Position B for liquid detergent. When you use the liquid detergent: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid then the maximum level. – Do not set the prewash phase. – Do not set the delay start. 9.3 Setting a programme 1. 2. Turn the programme knob and set the programme: – The related programme indicator comes on. – The indicator of the flashes.
ENGLISH Press again to start the programme immediately. 9.6 Interrupting a programme and changing the options You can change only some options before they operate. 1. Press . The indicator flashes. 2. Change the options. 3. Press again. The programme continues. 9.7 Cancelling a programme 1. 2. Turn the programme knob to to cancel the programme and to deactivate the appliance. Turn the programme knob again to activate the appliance. Now, you can set a new washing programme.
www.electrolux.com • After 5 minutes from the end of the washing programme Press the button pliance again. to activate the ap- The display shows the end of the last set programme. Turn the programme knob to set a new cycle. 10. HELPFUL HINTS AND TIPS 10.1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. • Obey the washing instructions that are on the laundry care labels. • Do not wash together white and coloured items.
ENGLISH 17 Use the correct quantity of the water softener. Obey the instructions that you find on the packaging of the product. 11. CARE AND CLEANING WARNING! Before maintenance, disconnect the appliance from the mains supply. 11.1 External cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. 11.2 Maintenance wash With the low temperature programmes it is possible that some detergent stays in the drum. Make regularly a maintenance wash.
www.electrolux.com 3. 4. 5. 6. 11.5 Cleaning the valve filter 1. 2.
ENGLISH 3. 4. 11.6 Cleaning the drain filter WARNING! Do not clean the drain filter if the water in the appliance is hot. 1. 2. 3. 4.
www.electrolux.com 5. 6. 1 2 7. 8. 9. 10. 2 1 11.7 Emergency drain 11.8 Frost precautions Because of a malfunction, the appliance cannot drain the water. If this occurs, do steps (1) through (10) of 'Cleaning the drain filter'. If necessary, clean the pump. When you drain the water with the emergency drain procedure, you must activate again the drain system: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water.
ENGLISH 5. 6. Empty the drain pump. Refer to the emergency drain procedure. When the drain pump is empty, install the inlet hose again. 21 WARNING! Make sure that the temperature is more than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 12. TROUBLESHOOTING The start of the appliance does not occur or it stops during operation. First try to find a solution to the problem (refer to the table). If not, contact the service centre.
www.electrolux.com Problem Possible solution Make sure that the drain hose has no kinks or bends. Make sure that the drain filter is not clogged. Clean the filter, if necessary. Refer to 'Care and cleaning'. Make sure that the connection of the drain hose is correct. Set the drain programme if you set a programme without drain phase. Set the drain programme if you set an option which ends with water in the tub. The spin phase does not operate or the washing cycle lasts longer than usually.
ENGLISH 23 Problem Possible solution The washing results are not satisfactory. Increase the detergent quantity or use a different detergent. Use special products to remove the stubborn stains before you wash the laundry. Make sure that you set the correct temperature. Decrease the laundry load. After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Service. If the display shows other alarm codes.
155248110-A-242013 www.electrolux.