User manual

16
O
5
Installation
All transit bolts and packing must be removed
before using the appliance.
Unpacking
You are advised to keep all transit devices so that th-
ey can be refitted if the machine ever has to betrantra-
nsported again.
Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine to its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing pieces
between the machines and the floor.
1.
Remove the polystyene block from the botton of
the machine and release the two plastic bags.
Carefully remove the right-hand bag then the left
bag by pulling them towards the centre of the
machine.
2.
3.
Plug the open holes with the plugs, which you will
find in the plastic envelope containing the instruc-
tion booklet.
5.
6.
7.
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets,rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place carboard, wood or similar materials
under the machine to compensate for any uneven-
ness in the floor. Or the machine will make abnormal
noise or vibrate during spin.
Positioning and levelling
Put the bottom cover in the right position.4.
Set the machine upright and remove the two remain-
ing bolts from the back.
Pull out the three plastic spacers from the holes into
which the bolts were fitted.
Put the juncture base A around the tap, fasten the
four screws and fix the inlet connector B, which
should ensure no water leakage.
To insert inlet tube in the sliding connector, press the
sliding knob C first, then put inlet tube in connector
B, and pull the tube to confirm if it is surely in
position.
Water inlet