User manual

7
You can alter the programme before it starts. When
the programme has started, you can only reset it by
turning the programme selector dial to “O” and then
you can select the new programme. The washing water
remains in the tub. Start the new programme by de-
pressing the Start/Pause button.
9. How to change a program during its
cycle
Press the Start/Pause button again
If it is necessary to drain the water in order to change
the program in progress, proceed as follows:
-
-
-
12. Open the door during the cycle
of a program
First set the machine to Pause by pressing the Start/
Pause button.
The door can be opened when the door locked light has
gone out. If the door does not open, this means that
the water temperature is above 55
, that the water
level is above the bottom edge of the door or that the
drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to“O”After about 3 minutes
the door can be opened (pay attention to the water
level and temperature!). Select the programme again
and depress Start/Pause to restart it.
13. At the end of the programme
The machine stops automatically. The door can only
be opened after the Door light has gone out.
Release of the lock is also indicated by the coming on
of the End light.
At the end of the programme turn the programme
selector dial to“O” to switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry
out another wash, close the water tap. Leave the door
open to prevent the formation of mildew and unpleas-
ant smells.
1
2
3
4
5
6
7
If you have selected the delay start, the delay time
value begins to count down.
Turn the programme selector dial to “O” to shut off
the machine
Then turn the programme selector dial to Drain
position
After the water has been drained, You can select a new
program and press the Start/Pause button to start it.
10. Interrupting a program
11. Cancelling a programme
Depress the Start/Pause button to interrupt a program
which is running, the corresponding light starts to flash.
Depress the button again to restart the program.
Turn the selector dial to “O” to cancel a programme
which is running. Now you can select a new programme.
14