User`s manual

3.5.2. Modifying the current programme

Before modifying the current programme, you must put

the washing machine to pause by pressing on the

«Start/Pause» pushbutton. If it is impossible to make

the modification, the corresponding light flashes for few

seconds. If you decide to change the programme in any

case, you will need to cancel the current programme

(see below).

3.5.3. Cancelling the programme

If you want to cancel a programme, turn the programme

selector knob to the «off» position of the programme

selector.

You can then select a new programme after cancelling

the previous one.

3.6. End of programme

The washing machine stops automatically. You will

hear a double "click" in the locking device when the

cover opens. The cycle end light goes on.

If you choose the rinse hold position*, the rinse hold li-

ght* illuminates to inform you that water has to be drai-

ned before you can open the cover. To terminate the

cycle, you can then spin the washing by choosing the

spinning programme or drain it by choosing the drai-

ning programme.

Turn the programme selector knob to the "Off" position.

Take out the laundry.

Pull out the power supply plug and close the water sup-

ply tap.

Note: we recommend that you should leave the cover

and the drum open after use to air the washing drum.

*depending on model

Downloaded From WashingMachine-Manual.com Manuals