User manual

You can turn it off by pressing “ ” and
“Delay End” buttons simultaneously.
Stain Wand - Operating Instructions
Before using Stain Wand, first verify the
fabric colour integrity by running the
preliminary test below:
To use Stain Wand, make sure both power
and water is turned ON in your machine.
1.
With the washing machine lid closed,
push “ ” and “Delay End” buttons
simultaneously for 3 seconds until
“WATER” and “ON” buttons are lit.
The Stain Wand is ready for use.
2.
Push the button “WATER” and direct the
water spray on the stain. Push the button
“WATER” as many times as necessary to
wet the stain. Repeat this procedure
every time the stain dries out.
For better removal stain must always
remain wet when using the device.
6.
Place the tip on the stain. While pressing
and holding button “ON”, gently drag the
tip on the stain in circular or “zig-zag”
movements.
7.
The cable has a locking position when
completely pulled out. Remove the Stain
Wand from its housing
and pull out cable
completely and release
so that it goes back and
locks at its intended
locking position.
3.
Spray a small amount of water in a
hidden area of the fabric;
1.1
Pour a small amount of colourless
liquid detergent;
1.2
Apply Stain Wand (according to the
instructions below) on this area;
1.3
Wait until the fabric dries out and
look for any signs of fading. If the
colour didn’t change you may use
the Stain Wand.
1.4
You may hear a peculiar sound emitted
when the ultrasound is working, this is
normal. For best results the Stain Wand
should work vertically.
This system was especially developed to
assist in the day-to-day work of removing
stains from your clothing. It works with
ultrasound technology combined with water
that emits vibrations that help loosen the
stains from fabric, turning their removal
easier when washing.
Place the tip
on the stain
Absorbing paper
or a clean cloth
Fabric
containing stain
Stain Wand Tip
Water Spray
Light
Remove any residue left over the stain by
using a small brush. Place an absorbing
paper or a clean cloth under the stain (this
paper or cloth will absorb the dirt). Since
the washing machine lid is closed, it may
be used as working area.
4.
As the stain goes “softer”, remove any
excess dirt and water that eventually
remains on the fabric by using an
absorbing paper or a clean cloth.
Change the paper/cloth under the stain
every time it is too wet.
8.
Repeat steps 5 to 7 if necessary.
Please Note: Some stains can not be
removed 100%.
9.
After use, return the Stain Wand on its
housing by pulling the cable gently until it
unlocks. As the cable retracts, place the
Stain Wand back in its housing.
10.
Add more detergent if necessary (in case
of persistent stains).
Pour two drops of colourless liquid
detergent on the stain.
5.
7