User manual

The washing machine can stop during the
spin stage of a wash because of an out of
balance condition. The display will show
“ ” and you will hear a short beep
every minute.
Always press buttons gently. Watch the
lights on the control panel to see the effect
pressing a button or turning a program
selector knob has, and listen for ‘BEEPS’.
When you press a button you will get a
short ‘BEEP’ to acknowledge the entry. If
the option is not available at the time, the
machine will not allow you to select it, and
you will here the long ‘BEEP’ to remind
you the option is not available.
After the machine has started, the entire
wash option button will be disabled and
machine will show “ ” on the display
with three short beeps to indicate the
button is disabled. The start button is still
active but you need to press and hold
the button for 1.2 seconds to pause
machine.
Out of balance during spin is caused by an
uneven distribution of clothes in the wash
bowl.
Out of Balance Interruption
Power failure recovery
Button Response and Lights
When there is power failure while machine
is washing or rinsing or spinning. The
machine tries to save the settings at which
stage the machine is doing and then when
the power returns back the machine
shows “ ” on the digital display.
If the Program or any other setting is not
changed within 5 seconds then the
machine starts washing from the stage
where it is left off.
Do not use Stain Wand continuously for
more than 5 minutes to avoid excessive
heat and always keep the stain wet by
spraying water during Stain Wand usage
which also helps to cool down Stain
Wand tip. For your safety, Stain Wand will
switch off after 5 minutes of continuous
use, but you can switch on again by
pressing “ON” button.
Use colourless liquid detergent only.
Do not use coloured detergents or
softeners. The colour of detergent or
softener may stain your fabrics even more.
Clothes that carry symbols:
are not suitable for Stain Wand pre-
treatment.
(do not wash at all), (do not
bleach), do not iron) and (dry
cleaning),
ATTENTION
NOTE
Depending on water supply pressure, you
may need to press button “WATER”
several times to inject water to make the
stain wet enough.
To test the Stain Wand, please spray
some water on lid by pressing button
“WATER” and then operate Stain Wand
tip on it by pressing button “ON”. If water
splashes that means Stain Wand is
functioning fine. If not, please contact
Customer Service.
To rectify the out of balance condition,
open the lid and redistribute the clothes
evenly in the space between the agitator
and wall of the wash bowl. Closing the lid
will start the machine and continue the
spin stage of the wash.
If you have frequent out of balance
interruptions, it may be due to your
washing machine not standing firm and
level on the floor. This can be corrected
by adjusting the washing machine legs as
described in the Installation Instructions
supplied with your machine.
8