User manual

CONTROL PANEL
All functions of the washing machine
will stop when the lid is open.
This mode permits you to either enable or
disable the beeping (4 beeps every 4
minutes) at the end of the wash. As an
example, you might wish to disable this
beeping when you start a wash when
going to bed, so that when the wash
finished approximately 1 hour later, it will
not disturb you through the night.
This is to confirm that you really want to
pause the machine. When in pause mode,
all options will be able to be changed again.
Enabling/Disabling
End-of-Wash Beeping Mode
NOTE: All error beeping is not disabled
by this feature, such as a critical fault,
or lid open during fill/agitate/spin, or
out of balance during spinning.
To change the “beeping” selection:
NOTE: If you do not press a button
within 5 seconds the washing machine
will return to the previous setting. To
reprogram, simply repeat the above
process.
Press the “Modify Option ( , )”
button to change the selection, then
press the Start/Hold To Pause button
to store the new selection.
2.
When the washing machine in
STAND-BY-MODE or PAUSE MODE,
press and hold “Start/Hold To Pause”
button for about 3 seconds to enter
Enabling/Disabling End-Of-Wash
Beeping mode.
The digital display will show “ ”
when the end of wash beeping is
disabled.
The digital display will show “ ”
when the end of wash beeping is
enabled (this is the default factory
setting).
1.
1
Program Select Touchpads
2
Reduce Time Touchpad
3
Modify Option Touchpads
4
Option Select Touchpads
5
Save Favourite Touchpad
6
Delay End Touchpad
7
Display
8
Stain Wand Option (see page 7)
9
Start/Hold To Pause Touchpad
2 23 3
4 5 6 891 7
9