User manual
• End of programme
When the programme has finished three
flashing zeros 0.00 are displayed. The
light of button 8 is off.
• Incorrect option selection
If an option not compatible with the set
wash programme is selected, the mes-
sage Err is displayed for a few seconds.
The integrated red light of button 8 flash-
es.
•
Alarm codes
Some alarm codes are displayed in the
event of operating problems (see para-
graph «What to do if... »).
•
Delay Time value
The selected delay appears on the dis-
play for a few seconds then the duration
of the previously set programme is dis-
played. The delay time value decreases
by one unit every hour and then. When 1
hour remains, the time decreases every
minute.
2.12: Soil degree icons
•
Intensive
•
Normal
•
Daily
•
Light
•
Quick
•
Super Quick
•
Refresh
•
Super Refresh
When you set a programme on the display
appears an icon indicating the degree of
soiling automatically proposed by the ma-
chine.
2.13: Clock icon
The duration of the set programme is dis-
played by the animation of the clock icon.
2.14: Drying programme phase icons
•
= Drying
•
= Anti-crease
When you set the drying programme, all
drying phase icons are shown. When the
programme has started, the only icon of the
running phase stays on.
2.15: Washing programme phase icons
•
Prewash
•
Wash
•
Rinses
•
Drain
•
Spin
When you set the washing programme, all
washing programme phase icons are
shown. After the programme has started,
the only icon of the running phase stays on.
FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Before the first wash, run a cotton
cycle at the highest temperature
without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start the
machine.
PERSONALISATION
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• if there is a fault.
By pressing the 5 and 6 buttons simultane-
ously for about 6 seconds, the acoustic
signal is deactivated (except if there is a
fault). By pressing these 2 buttons again,
the acoustic signal is reactivated.
CHILD SAFETY LOCK
This device permits you to leave the appli-
ance unattended and not to worry that chil-
dren might be injured by or cause damage
to the appliance. This function remains ena-
bled also when the washing machine is not
working.
There are two different ways to set this op-
tion:
1. Before pressing button 8: it will be im-
possible to start the machine.
8 electrolux