User manual

Interrupting a programme
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 8 .
After a few minutes the pilot light 9 goes
out and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O . After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!) .
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8 .
At the end of the programme
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some acous-
tic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1.
Turn the programme selector dial to O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
Stand by : once the programme has finish-
ed after a few minutes the energy saving sys-
tem will be enabled. The brightness of the
display is reduced. By pressing any button
the appliance will come out of the energy
saving status.
DRYING BOARD - HOW TO DRY
General safety
Warning!
• Before using the drying board,
MAKE SURE that the washing ma-
chine is switched off . The drying
board and the washing machine
CAN NOT work at the same time.
The use of drying board automatical-
ly excludes the washing machine.
• If you activate the drying board while
the washing machine is working, the
washing stops immediately and it is
switched off. At the end of the drying
programme, after the ACTIVATE but-
ton is pressed or after 10 minutes (au-
tomatic switching off of the drying
board ) the washing starts again
from the running phase interrupted
previously.
• Children should be supervised to en-
sure that they do not play with the ap-
pliance.
• When it's not necessary, DO NOT
leave the extractable shelf open, to
prevent that the children hang on it.
electrolux 11
Downloaded From WashingMachine-Manual.com Manuals