User manual

Malfunction Possible cause Solution
The door will not open: The programme is still
running.
The door lock has not been
released.
There is water in the drum.
Wait the end of washing
cycle.
Wait for some minutes until
the door lock is released.
Select drain or spin
programme to empty out
the water.
No water is visible in the
drum
Machines based on modern
technology operate very
economically using very little
water without affecting
performance.
There is water on the floor: Too much detergent or
unsuitable detergent
(creates too much foam)
has been used.
Check whether there are any
leaks from one of the inlet
hose fittings. It is not always
easy to see this as the water
runs down the hose; check
to see if it is damp.
The drain hose is damaged.
The drain filter has not fully
screwed in after cleaning.
Reduce the detergent
quantity or use another one.
Check the water inlet hose
connection.
Replace it with a new one.
Screw fully in the drain filter.
The machine does not fill: The water tap is closed.
E10
The inlet hose is squashed or
kinked.
E10
The filter in the inlet hose is
blocked.
E10
The door is not properly
closed.
E40
Open the water tap.
Check the inlet hose
connection.
Clean the water inlet hose
filter.
Close firmly the door.
what to do if... electrolux 31
Unsatisfactory washing
results:
Too little detergent or
unsuitable detergent has
been used.
Stubborn stains have not
been treated prior to
washing.
The correct temperature
was not selected.
Excessive laundry load.
Increase the detergent
quantity or use another one.
Use commercial products to
treat the stubborn stains.
Check if you have selected
the correct temperature.
Introduce into the drum less
laundry.
132966410_GB.qxd 10/01/2008 9.34 Pagina 31