User manual

38 electrolux installation
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine. In this
case, make sure the end cannot come
unhooked when the machine is
emptying. This could be done by tying it
to the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
Directly into a drain pipe at a
height of not less than 60 cm and not
more than 90 cm. The end of the drain
hose must always be ventilated, i.e.
the inside diameter of the drain pipe
must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
P0022
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Centre.
Electrical connection
Information on the electrical connection
is given on the rating plate on the inner
edge of the appliance door and in the
chapter «Technical Data».
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the machine to an earthed
socket.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
Should the appliance power supply
cable need to be replaced, this must
be carried out by our Service Centre.
Please ensure that when the appliance is
installed the power supply cable is easily
accessible
P1059
132966410_GB.qxd 10/01/2008 9.35 Pagina 38