User manual

Preparation and assembly of the
door
The machine is originally designed for
the assembly of a door opening from
right to left.
In this case it is sufficient to screw in the
hinges (1) and the counter-magnet (6)
provided with the appliance, at the right
level (Fig. B).
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the
height of the adjacent furniture's base.
35 Ø 12.5-14 depth
16-22
B
C
22+1,5
595-59
8
416
P0422S
C
4
1
2
3
6
1
2
3
P0982
7
B
5
b) Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth 12.5-
14 mm depending on the depth of door
furniture) on the inner side of the door.
The distance between the holes hobs
fixing centres must be 416 mm.
The distance (B) from upper edge of the
door to the centre of the hole depends
on the adjacent furniture's dimensions.
The required dimensions are given in
the picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B)
supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by
means of the M5x15 screws (3-Fig. B).
The hinges can be adjusted to compen-
sate for possible uneven thickness of
the door.
To align the door perfectly it is neces-
sary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw
again.
d) Counter-magnet (6)
The appliance is designed for a
magnetic closure of the door. To enable
the correct operation of this device, it is
necessary to screw the counter-magnet
(6) (steel disk + rubber ring) into the
inner side of the door.
Its position must correspond to the
magnet (4) on the appliance (see pic-
ture D).
40 electrolux installation
132966410_GB.qxd 10/01/2008 9.35 Pagina 40