User manual

GB
16
Traditional cooking with powered fan
By selecting this function you start the two upper and lower
resistances and heat circulates evenly around the food by
means of a powered fan. To select this function you should
turn the thermostat knob to the desired temperature.
This function is suitable for cooking on a single shelf.
Light oven
By selecting this function you start the lower resistance.
To select it you should turn the thermostat knob to the de-
sired temperature. You can choose this type of cooking
when you need to cook better the bottom of your food.
ELECTRIC GRILL - FUNCTIONING
AND INSTRUCTIONS FOR USE
- To open the oven door always grasp the handle in the centre.
- During or at the cooking ending pay attention to possible
emission of superheated steams when you open the door.
- Always use thermal gloves to put pans in or out the oven.
- After appliance use make sure that all controls are in
off/closed position.
For appliances equipped with electric oven the electric grill
function may be used with closed door.For appliances
equipped with gas oven the electric grill shall be used with
half-open door and handgrip heat-shield mounted; as the
grill is an element used for final touch-ups it is advisable to
use it for max 20 minutes.
USE OF ACCESSORIES
Timer
Your range can be fitted with this accessory that you can
wind by rotating the corresponding knob clockwise by one
complete turn and set the pointer to the desired cooking ti-
me (expressed in minutes) by rotating the knob counter-
clockwise. The set time running out will be signaled by a bell.
Electric timer
Your range can be fitted with this accessory acting both as
a clock and as a timer as well. To set hour push and rota-
te the small knob counterclockwise. To set minutes rotate
the small knob counter clockwise without pushing it.
Timer with cooking end function
Your range can be fitted with this double functional acces-
sory: it can show the cooking time that has already passed
and automatically turn off the oven. You can set the desi-
red cooking time by rotating the timer knob clockwise;
when this time has passed the acoustic warning signal
switches on and contemporaneously the automatic co-
oking end device starts.
As far as the oven connection modes are concerned plea-
se refer to the handbook specific paragraphs.
If you desire to use the oven without the timer function you
should turn the knob to the symbol (manuel).
N.B. When the knob pointer is set to “0” position, oven
cannot work.
Electric clock supplied with cooking end device
Range can be fitted with this double functional accessory:
it consists of a clock able to turn off oven automatically
when the set cooking time has run out.
To set hour push and rotate the small knob counterclock-
wise.
To set minutes rotate the small knob counterclockwise wi-
thout pushing it.
When the set time has run out the acoustic warning signal
starts to inform that oven is off.
Turn the knob to the symbol to stop it.
If you desire to use oven without setting a cooking time you
should rotate the knob pointer counterclockwise to the
symbol (manuel).
N.B. When the knob pointer is set to “0” position and
to symbol , oven cannot work.
Electronic programmer
Your range can be fitted with this accessory whose main
functions are:
- Clock (to be set with push buttons 2 and 3).
- Timer (to be set with push button 1).
- Cooking time (to be set with push button 2).
- Cooking end time (to be set with push button 3).
- Manual working (to be set with push button 4).
- Regulation of times “backward” (to be set with push button 5).
- Regulation of times “forward” (to be set with push button 6).
The digital display “D” (see pict. 4 at the end of this hand-
book) shows the hour, the cooking time and the cooking
end time.
Time setting
After the electric connection or a lack of current, on the
display the “AUTO” e “0.00” signals will flash at the same
time. Push and release contemporaneously push buttons 2
and 3 and start setting the current hour by pushing either
button 4 or 5 within 4 seconds. Once the setting is over no
symbol will be on.
Timer
Push button 1 and select your cooking time by means of ei-
ther button 4 or 5.
The symbol will lit up.
When the set time has run out, the acoustic warning signal
starts and the symbol will flash. After the bell discon-
nection that symbol will disappear.
Half-automatic working mode (cooking time)
By pushing button 2 and setting the cooking time by means
of button 5, both the “AUTO” and the symbol will lit up.
When the set time has run out, the symbol will switch
off while the “AUTO” symbol flashes and the acoustic war-
ning signal starts.
Half-automatic working mode (end of cooking time)
By pushing button 3 and setting the end of cooking time by
means of button 5, both the “AUTO” and the symbols
will lit up.
When the set time has run out, the symbol will switch
off while the “AUTO” symbol flashes and the acoustic war-
ning signal starts.
Automatic working mode (postponed cooking start time)
First you should set your cooking time (both the “AUTO” and
the symbols will lit up) and then the cooking end time,
the symbol will switch off as previously stated.
The symbol will lit up again when the oven starts baking.
When cooking time has run out, the symbol will switch
off while the ”AUTO” symbols flashes and the acoustic war-
ning signal starts.
Manual working
Manual working is possible only after having cleared the
automatic program by pushing button 3. The “AUTO”
symbol disappears and no other symbols lit up.
Acoustic warning signal
The acoustic warning signal starts at the end of a program
and lasts about two minutes. To interrupt it you should
push one of the function buttons.
Program start and check
Program starts after about 4 seconds from the setting. It is
possible to check the set program at any time by pushing
the corresponding button.
Correction and cancellation of program
It is possible to correct the set program at any time by first
pushing the relative programming button and then buttons
4 or 5. It is possible to cancel a program by changing the
set time to “0.00”. By cancelling the working time you will
automatically cancel the working end time and vice versa.
Oven automatically switches off while the “AUTO” symbol
flashes. Push button 3 to set the programmer to manual
working mode. Time cannot be corrected when the auto-
matic working program is on.