User manual

The cleaning results are not satisfactory
There are streaks, milky
spots or a bluish coating on
glasses and dishes
• Decrease the rinse aid dosage.
Dry water drop stains on
glasses and dishes
• Increase rinse aid dosage.
• The detergent can be the cause.
TECHNICAL DATA
Dimensions Width (mm) 596
Height (mm) 818 - 878
Depth (mm) 575
Electrical connection - Voltage -
Overall power - Fuse
Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher door.
Water supply pressure Minimum 50 kPa (7 psi)
Maximum 800 kPa (116 psi)
Capacity Place settings 12
INSTALLATION
If oor is not level, adjust
levelling legs to suit
POWE R S UPPL Y
230/240V
-10Am
p
s
The hos e s hould not be
extended by more than
2 metres or water pump-
out
problems ma y occu r
Fix drain hose max of
10mm below the top of
the dishwashe r
Remove entire plastic
membrane from sink trap
spigot & fit drain hose to spigot
with clamp
There should be a minimum
2mm gap between the top of
the dishwasher and
underside of bench top
• K ickplate xing screws •
Gap on both sides should be
equal, & no greater than
5mm per side.
600mm max.
300mm min.
Secure dishwasher with
brackets and screws provided
Inlet water supply
• Cold water pressure: 800 kPa max -
50 kPa min
• Water flow rate 10 L/minute min.
• If cold water pressure is in excess of
800 kPa, a pressure-reducing valve
should be used. Check for leaks.
16 electrolux