User manual

Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Install the appliance under a counter (kitch-
en worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and drain.
For the venting of the appliance only water
hoses and mains cable openings are nec-
essary.
The appliance has adjustable feet to allow
the adjustment of its height.
Make sure that the water inlet hose, the
drain hose and the mains cable are not
kinked or squashed, when you insert the
appliance.
Make sure that the dimensions of the re-
cess agree with the given dimensions.
Adjusting the height of the appliance
Follow these steps to adjust the height of
the appliance
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable
plinth.
3. Adjust the rear foot. Turn the screw in
the middle of the front kick-plate to the
left or to the right.
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. Loos-
en or tighten the adjustable feet until the
appliance is level.
Adjusting the height of the plinth
If there is a space between the floor and the
bottom of the appliance, you can lower the
plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of
the kitchen counter along the entire width.
600 mm
Fixing to the adjacent units
Warning! Use the supplied brackets to
attach the appliance under the kitchen
counter or to the adjacent units, to
prevent injury or damage.
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
electrolux 17