User manual

• to activate/deactivate the multitab func-
tion. Refer to 'Multitab function'.
• to deactivate/activate the rinse aid dis-
penser when multitab function is active.
Refer to 'Multitab function'.
• to cancel the washing program in pro-
gress or a delay start in progress. Refer
to 'Select and start a washing program'.
Setting mode
The appliance must be in setting mode
for these operations:
• To set a washing program.
• To set the water softener level.
• To deactivate/activate the audible sig-
nals.
• To deactivate/activate the rinse aid dis-
penser.
Press the on/off button. The appliance
is in setting mode when:
– All the program indicator lights are on.
Press the on/off button. The appliance
is not in setting mode when:
– Only one program indicator light is on.
– A washing program is set. It is necessary
to cancel the program to go back to the
setting mode. Refer to "Select and start a
washing program".
Audible signals
You can hear an audible signal:
• at the end of the washing program,
• during the setting of the level of the water
softener,
• when the appliance has a malfunction.
The activation of the audible signals is set at
the factory.
Do these steps to deactivate the audible
signals:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C until the indicator lights of function
buttons A, B and C start to flash.
4. Press the function button C.
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
Audible sig-
nals deacti-
vated
Audible sig-
nals activated
The audible signals are activated.
5. Press the function button C again.
– The digital display shows the new
setting.
The audible signals are deactivated.
6. Switch off the appliance to save the op-
eration.
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
display shows necessary setting.
USE OF THE APPLIANCE
Refer to specified instructions for each step
of the procedure.
1. Fill the rinse aid dispenser with rinse
aid.
2. Load cutlery and dishes into the appli-
ance.
3. Set the correct washing program for
the type of load and soil.
4. Fill the detergent dispenser with the
correct quantity of detergent.
5. Start the washing program.
USE OF RINSE AID
Caution! Only use rinse aid specified
for dishwashers.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
ing agent, liquid detergent). This can
cause damage to the appliance.
Rinse aid makes it possible to dry the
dishes without streaks and stains.
Rinse aid is automatically added during
the last rinsing phase.
Follow these steps to fill the rinse aid dis-
penser:
electrolux 5