Use & Care Guide

27
Care & Cleaning
1. Turn off the water supply to washer to avoid
water leaks due to water pressure surges and
unforeseen occurrences in the water supply.
2. Disconnect or unplug the electrical power to
the washer.
3. Remove excess water from the dispenser,
interior door and tub and perform the Care
and Cleaning steps.
1. Review the Installation Instructions provided
with the washer to ensure the appliance is
level and the water and electrical power sup-
ply is properly connected.
2. Ensure the water lines are flushed of debris,
prior to connecting the water lines to the
washer inlet.
3. Check for water leaks and replace supply
hoses if needed.
Instructions for Limited Use, Vacation, and Away from Home
Reconnecting Water Supply and Electrical
IMPORTANT
Your washer should be operated ONLY when
you are home. If you are away from home or
not using your washer for extended periods of
time, follow these steps:
IMPORTANT
When reinstalling the washer after
disconnecting the water supply lines and
electrical power, please follow the steps
below:
Water Inlet Hose Inspection
Periodically inspect all water inlet hoses for
water leaks, wear, cuts, corrosion and bulges.
Replace all hoses, if any sign of the above is
visible. All hoses should be replaced every
5 years to reduce the risk of hose failures.
When replacing hoses, refer to the Installation
Instructions for proper installation. Do not
overtighten or cross thread the fittings. Do not
allow the hose to rub against sharp objects.
Always ensure the hose fitting rubber gasket is
installed and free from water leaks when water
pressure is applied.
RUBBER WASHERS
MUST BE PRESENT
REPLACE HOSES EVERY 5 YEARS
Grounding type
wall receptacle
Power cord with
3-prong grounded plug
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.