User manual

WARNING!
Do not squeeze the gas
supply ramp and the pipe
when you move the oven
into the built-in cabinet.
8. Seal the connection correctly. Use a
leak detection to control it.
3.2 Adjustment to different
types of gas
Only a qualified technician is authorized
to handle adjustment of different types of
gas.
The oven is set for different types of gas,
you can switch between liquid gas and
natural gas with the correct injectors.
The gas rate is adjusted to suit.
WARNING!
Before you replace the
injectors, make sure that the
gas knobs are in the off
position. Disconnect the
oven from the mains. Wait
until the oven is cold. There
is a risk of injury.
3.3 Oven injector replacement
1. Remove the bottom plate of the oven
cavity (A) to get access to the oven
burner (B).
AB
2. Release the screw (C), which keeps
the burner in position.
C
3. Carefully move the burner off the
injector support (D).
D
E
F
4. Slowly move it to the left side. Do not
apply force to the wire of the spark
plug connector (F) and to the
thermocouple conductor (E).
5. Release the burner injector (D) with a
7 mm socket spanner and replace it
with a different one, which is
necessary for the type of gas you
use.
Refer to “Technical data” chapter.
6. Assemble the burner in a reverse
sequence.
Replace the gas type sticker near the
gas supply ramp with the one related to
the new gas type.
The gas oven burner does not need any
primary gas regulation.
www.electrolux.com8