User manual

Make sure that the gas
supply pressure of the
appliance is in line with the
recommended values.
If the supply gas pressure is
changeable or different than
the necessary pressure, you
must fit an applicable
pressure adjuster on the gas
supply pipe.
3.4 Minimum level adjustment
of the oven burner
1. Disconnect the oven from the mains.
2. Turn the knob for the gas control to
the minimum position and remove it.
3. Adjust the adjustment screw (A) with
a thin-bladed screwdriver.
A
Change of
the type of
gas
Adjustment
of the ad‐
justment
screw
From natural
gas to liquid
gas
Fully tighten
the adjust‐
ment screw
in.
From liquid
gas to natu‐
ral gas
Release the
adjustment
screw ap‐
proximately
1/3 of a turn.
4. Attach the knob for the gas control.
5. Connect the oven to the mains.
WARNING!
Only put the mains plug into
the mains socket when all
parts are back into their
initial position. There is a risk
of injury.
6. Light the gas oven burner.
Refer to "Daily use" chapter.
7. Set the knob for the gas control to
the maximum position and let the
oven heat for at least 10 minutes.
8. Turn the knob for the gas control
from the maximum to the minimum
position.
Control the flame. If the flame goes out,
do the procedure again. There must be a
small regular flame on the oven burner
crown.
The manufacturer objects liability if
you do not obey to this safety
measures.
3.5 Building In
Only set up the appliance in a kitchen or
in a kitchen-dining room. Do not set up
the appliance in a bathroom or a
bedroom.
You can install the appliance "built-in" or
"built-under". The dimensions of the built-
in cabinet must agree with the related
illustrations.
ENGLISH 9