User manual

WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
The lamp glass cover is at the
back of the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
11.7 Removing the drawer
WARNING!
When the oven is in use, heat
can build up in the drawer.
Do not keep flammable
things in there (e.g. cleaning
materials, plastic bags, oven
gloves, paper, cleaning
sprays, etc.).
The drawer below the oven can be
removed for cleaning.
1. Pull the drawer out until it stops.
1
2
2. Lift the drawer at a small angle and
remove it from the drawer support
rails.
Inserting the drawer:
1. To insert the drawer set the drawer on
the support rails. Make sure that the
catches engage correctly into the rails
2. Lower the drawer until it is horizontal
and push it in.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem Possible cause Remedy
You cannot activate the ap-
pliance.
The appliance is not con-
nected to an electrical sup-
ply or it is connected incor-
rectly.
Check if the appliance is
correctly connected to the
electrical supply.
www.electrolux.com18