User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. OPERATION
- 4. DAILY USE
- 5. HINTS AND TIPS
- 6. CARE AND CLEANING
- 7. TROUBLESHOOTING
- 8. INSTALLATION
- 9. NOISES
- 10. TECHNICAL DATA
- TABLE DES MATIÈRES
- 1. CONSIGNES DE SÉCURITÉ
- 2. INSTRUCTIONS DE SÉCURITÉ
- 3. FONCTIONNEMENT
- 4. UTILISATION QUOTIDIENNE
- 5. CONSEILS
- 6. ENTRETIEN ET NETTOYAGE
- 7. EN CAS D'ANOMALIE DE FONCTIONNEMENT
- 8. INSTALLATION
- 9. BRUITS
- 10. CARACTÉRISTIQUES TECHNIQUES
- INHALTSVERZEICHNIS
- 1. SICHERHEITSHINWEISE
- 2. SICHERHEITSANWEISUNGEN
- 3. BETRIEB
- 4. TÄGLICHER GEBRAUCH
- 5. TIPPS UND HINWEISE
- 6. REINIGUNG UND PFLEGE
- 7. FEHLERSUCHE
- 8. MONTAGE
- 9. GERÄUSCHE
- 10. TECHNISCHE DATEN
- CONTENIDO
- 1. INFORMACIÓN SOBRE SEGURIDAD
- 2. INSTRUCCIONES DE SEGURIDAD
- 3. FUNCIONAMIENTO
- 4. USO DIARIO
- 5. CONSEJOS
- 6. MANTENIMIENTO Y LIMPIEZA
- 7. SOLUCIÓN DE PROBLEMAS
- 8. INSTALACIÓN
- 9. RUIDOS
- 10. DATOS TÉCNICOS
• Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
• Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
2. SAFETY INSTRUCTIONS
2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging and the
transit bolts.
• Do not install or use a damaged
appliance.
• Follow the installation instruction
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Make sure the air can circulate
around the appliance.
• Wait at least 4 hours before
connecting the appliance to the power
supply. This is to allow the oil to flow
back in the compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where
there is direct sunlight.
• Do not install this appliance in areas
that are too humid or too colds, such
as the construction appendices,
garages or wine cellars.
• When you move the appliance, lift it
by the front edge to avoid scratching
the floor.
2.2 Electrical connection
WARNING!
Risk of fire and electrical
shock.
• The appliance must be earthed.
• Make sure that the electrical
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the electrical components (e.g. mains
plug, mains cable, compressor).
Contact the Authorised Service
Centre or an electrician to change the
electrical components.
• The mains cable must stay below the
level of the mains plug.
• Connect the mains plug to the mains
socket only at the end of the
installation. Make sure that there is
access to the mains plug after the
installation.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
2.3 Use
WARNING!
Risk of injury, burns,
electrical shock or fire.
www.electrolux.com4