User manual

16
11. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
“Start/Pause” button.
If the door does not open after two minutes, this
means that the water temperature is above 55°C,
that the water level is above the bottom edge of the
door or that the drum is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to 0. After about 2 minutes
the door can be opened (pay attention to the water
level and temperature!).
Select the programme again and depress
“Start/Pause” to restart it.
12. At the end of the programme
The machine stops automatically.
Release of the lock is also indicated by the coming
on of the End light.
At the end of the programme turn the programme
selector dial to 0 to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another wash, close
the water tap. Leave the door open to prevent the
formation of mildew and unpleasant smells.
7. Start the programme
To start the selected programme, press the
“Start/Pause” button; the corresponding light stops
flashing.
The In progress light illuminates.
The machine starts operating.
8. Altering an option or a running
programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “Start/Pause”
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to 0
and then to the new programme position. The
washing water in the tub will not emptied out.
Start the new programme by depressing the
“Start/Pause” button.
Note: To drain the water before starting the new
cycle, you have to cancel the programme and select
the Drain cycle (14).
9. Interrupting a programme
Depress the “Start/Pause” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
10. Cancelling a programme
Turn the selector dial to 0 to cancel a programme
which is running. Now you can select a new
programme.
Start/
Pause